Type of aluminum needed
Type of aluminum needed
I am thinking about changing the key heads on my GFI student so I can go to better tuners. They are 1/2" x 3/4" bars. What would be the best type of aluminum to use? I probably will polish them instead of painting them crinkle black like GFI did.
Scott Duckworth
E6 Rogue lap steel, D6 Regal RD-30MS squareneck reso-guitar,
Li'l Izzy, Zoom MS-50G Effects Pedal into a Berhinger mixer and Harbinger V2112 speaker(s).
Amateur Radio Operator NA4IT (Extra)
http://www.qsl.net/na4it
E6 Rogue lap steel, D6 Regal RD-30MS squareneck reso-guitar,
Li'l Izzy, Zoom MS-50G Effects Pedal into a Berhinger mixer and Harbinger V2112 speaker(s).
Amateur Radio Operator NA4IT (Extra)
http://www.qsl.net/na4it
Re: Type of aluminum needed
6061-T6 Aluminum is the most commonly used on a steel. Most readily available as well.
http://benrom.com/
21 BenRom pedal steel guitars, a Nash 112 and a 1967 TOS Milling machine with many cutters making one hell of a mess on the floor.
21 BenRom pedal steel guitars, a Nash 112 and a 1967 TOS Milling machine with many cutters making one hell of a mess on the floor.
Re: Type of aluminum needed
Thanks Bent, that's what I was thinking, just wanted to make sure.
Scott Duckworth
E6 Rogue lap steel, D6 Regal RD-30MS squareneck reso-guitar,
Li'l Izzy, Zoom MS-50G Effects Pedal into a Berhinger mixer and Harbinger V2112 speaker(s).
Amateur Radio Operator NA4IT (Extra)
http://www.qsl.net/na4it
E6 Rogue lap steel, D6 Regal RD-30MS squareneck reso-guitar,
Li'l Izzy, Zoom MS-50G Effects Pedal into a Berhinger mixer and Harbinger V2112 speaker(s).
Amateur Radio Operator NA4IT (Extra)
http://www.qsl.net/na4it