Well here is my progress so far.... Been cleaning and polishing up the aluminum parts..
A knee bar, some stops...
I have only 3 bags of parts to go! Not bad considering I had 10. Than I have to assemble it all... LOL
Hello From Toronto Pedal Bar Help Needed!
Re: Hello From Toronto Pedal Bar Help Needed!
- Attachments
-
- parts.JPG (151.41 KiB) Viewed 7327 times
-
- Posts: 332
- Joined: Sun Jan 23, 2011 5:06 am
- Location: Northern Ontario
Re: Hello From Toronto Pedal Bar Help Needed!
Hey Alex,
Isn't the cleaning and polishing the best part of the project. I bet you wish you had 10 more bags.lol
Paul
Isn't the cleaning and polishing the best part of the project. I bet you wish you had 10 more bags.lol
Paul
Re: Hello From Toronto Pedal Bar Help Needed!
ha ha yes Paul, I would love to have more tiny parts to polish up...
But hey once they are done I can start to put them back on the guitar!
A.
But hey once they are done I can start to put them back on the guitar!
A.
-
- Posts: 332
- Joined: Sun Jan 23, 2011 5:06 am
- Location: Northern Ontario
Re: Hello From Toronto Pedal Bar Help Needed!
Hi Alex,
If you run into problems post your questions in the Pedal Steel portion of the forum. You will definitely get more responses there. I'm looking forward to seeing your project completed.
Paul
If you run into problems post your questions in the Pedal Steel portion of the forum. You will definitely get more responses there. I'm looking forward to seeing your project completed.
Paul