My pedal steel No 2

[sheffield steel]

Looking SWEEEEEEEET!!!!!! Ron my friend, keep up the good work.

Dave.

[maxi19]

Thanks everyone.

Ron Mc

[Blacksb21]

Hello Maxi what is the dimension of your finger changer?
Steve B.

[maxi19]

Hi Steve, if you mean the overall dim's of a finger, it's 130mm x 20mm x 6.5mm. The finger block is 108 x 40 x 20 with 6.5 wide slots with a spacing off 2mm walls between each slot.

Regards Ron Mc

[Blacksb21]

Hello maxi19 sorry to get off the subject of pedal changers, but I have veneered my steel guitar, my issue is when I get ready to put finish on the guitar I have a line to try to make smooth looking and that is where the top veneer meets with the front veneer, how do I keep this edge line from showing thru stain? Steve B.

[maxi19]

Hello Steve,

I don't use veneer but if I did I would use an aluminium angle section for the edging, it can be obtained in 9.5 mm x 9.5 mm x 1.6 mm which is 3/8" x 3/8" x 1/16" which looks neat when polished.

Best Regards

Ron Mc

[Blacksb21]

Hey Maxi19 what is the shaft holes distance and what is the length of your front and back rails? Steve B.

[maxi19]

30mm between centres, and you would have to make the rails to your own specs depending on your planned cabinet size.

[maxi19]

Steel assembled, just the laborious 'setting up' to do, a job I find involves going round and round in ever decreasing circles.

Best Regards to all.

[maxi19]

2 more shots