Setting Up A Pull Release - C6
Posted: Sun Jul 10, 2011 10:05 pm
I'm having a bit of difficulty setting up.
1.) For now my pedal travel is stopped by the table top - no problem this I can rectify later.
2.) Strings 4 and 8: Pedal 2 raises both A's to B's so far so good.
3.) Pedal 2 raises string 1 from a G to a G# and Lowers string 5 to an F#. Here's where I'm having problems.
I can get the G# balanced to within 8 cents and the G to within 8 cents. I don't think my pedal rod is too short, but, I may need helper springs and if so where do I put them. The lower has a spring already but the raise does not. I hope I've explained the problem. If you have questions please ask away.
I'll be grateful for any help I can get.
1.) For now my pedal travel is stopped by the table top - no problem this I can rectify later.
2.) Strings 4 and 8: Pedal 2 raises both A's to B's so far so good.
3.) Pedal 2 raises string 1 from a G to a G# and Lowers string 5 to an F#. Here's where I'm having problems.
I can get the G# balanced to within 8 cents and the G to within 8 cents. I don't think my pedal rod is too short, but, I may need helper springs and if so where do I put them. The lower has a spring already but the raise does not. I hope I've explained the problem. If you have questions please ask away.
I'll be grateful for any help I can get.