Page 1 of 1
A question about changer rods to bell crank bushings.
Posted: Sun Sep 20, 2015 1:49 pm
by Blacksb21
Hello can anyone give me a resource to 6mm bronze rod connector bushings with center black set screws that fit in the bell crank holes? would love to order them, I think they are 6mm or 15/64" Steve Black.
Re: A question about changer rods to bell crank bushings.
Posted: Fri Oct 02, 2015 4:48 pm
by Bill Ford
Look at these, I ordered some, but you have to drill for the rods..BF
http://www.mcmaster.com/#standard-threa ... fs/=z73808
Re: A question about changer rods to bell crank bushings.
Posted: Sat Oct 03, 2015 1:46 am
by bluesteel
I got myself one of those little Chinese lathes second hand a while back, so I just make my own out of round brass bar. We don't have McMaster-Carr in the UK anyway...
Re: A question about changer rods to bell crank bushings.
Posted: Sun Oct 04, 2015 6:49 am
by Blacksb21
Hello bluesteel, did you hire the Chinese man as well.
Re: A question about changer rods to bell crank bushings.
Posted: Sun Oct 04, 2015 6:56 am
by Blacksb21
I am having issues with my bell cranks not having enough threads to attach them to the cross shafts, if I tightened them down too much they strip out, and they need to be tight, I got my rod connector bushings to work quite well, but the bell crank just won'the tightened down, I have another idea I will try, but could use any ideas you guys have.