Changer finger
Re: Changer finger
He's not known as the spring man for nothing, Ron!
Re: Changer finger
Good morning all,
Just a photo of the progress with this new changer.
Best Regards Ron Mc
Just a photo of the progress with this new changer.
Best Regards Ron Mc
- Attachments
-
- tn_DSCF1457.JPG (102.5 KiB) Viewed 2197 times
Re: Changer finger
Good afternoon all,
some more views of the changer fingers assembled, I put a raise spring assist hole at 'Burt's' advice in each finger but everything has had to slow down at the moment as I have a bit of maintenance on the boat.
Best Regards to all Ron Mc
some more views of the changer fingers assembled, I put a raise spring assist hole at 'Burt's' advice in each finger but everything has had to slow down at the moment as I have a bit of maintenance on the boat.
Best Regards to all Ron Mc
- Attachments
-
- tn_DSCF1461.JPG (124.48 KiB) Viewed 2174 times
-
- tn_DSCF1460.JPG (113.33 KiB) Viewed 2174 times
-
- tn_DSCF1459.JPG (129.36 KiB) Viewed 2174 times
Re: Changer finger
Can we have some dimensions on the fingers.?
Re: Changer finger
You certainly can my friend, Iv'e attached some j-pegs, hope they are of use.
Best Regards
Ron Mc
Best Regards
Ron Mc
- Attachments
-
- tn_img004.jpg (58.27 KiB) Viewed 2087 times
-
- tn_img003.jpg (47.25 KiB) Viewed 2087 times
Re: Changer finger
Very nice and neat What guage is the sheet metal your using? I was looking for a new changer and found yours , may I give it a try ?
Re: Changer finger
I used 16 swg but 1 mm thick would be sufficient
-
- Posts: 76
- Joined: Thu Apr 03, 2014 12:42 pm
Re: Changer finger
looking good, Ron.
What type of rivets are you using? how are they fitted? thanks
What type of rivets are you using? how are they fitted? thanks
Re: Changer finger
Hi Jason,
if you follow this link http://www.ebay.co.uk/itm/350416353188 you will see the type of rivets I use.
I use washers made from thin ptfe sheet between the 'scissor' joints and a steel washer on the riveted end.
Ron Mc
if you follow this link http://www.ebay.co.uk/itm/350416353188 you will see the type of rivets I use.
I use washers made from thin ptfe sheet between the 'scissor' joints and a steel washer on the riveted end.
Ron Mc