My Sheffield D10 is slowly taking shape

[Blacksb21]

Hello Dave, finally got the border trim routed out on my guitar ready to install my border trim, where do I put the glue, on the border trim or on the area of the guitar where border goes?
Steve B.

[sheffield steel]

Hi Steve, depending on the type of glue that you use is where you will apply it. I use super glue and Just run some in the routed groove, approximately 4" or so at a time because it dries very fast, then quickly insert your inlays into the groove making sure that the inlays are sitting correctly, then hold in place with some strips of tape. Repeat this operation until you've completed said inlay/s, when dry, remove tape and sand to a smooth finish. NOTE!!! LOTS OF PATIENCE IS REQUIRED!!!!!
I hope this helps. Dave.

[Blacksb21]

Hey Dave hope you are having a great weekend, how did you make your pedal changer housing? is there a way to make a finger changer housing with out machining? Steve B.

[sheffield steel]

CNC machined out of a solid block of aluminum. You could have a post at either end like an Emmons style with a 13-14mm cross shaft/axle shaft but to get it all to very close tolerances by hand you will have to have a lot of patience. Dave

[sheffield steel]

My new baby, Santa's been early, I must have been a good boy?
May you all have a Very Merry Christmas & a Happy New Year. Dave.

[Storm Rosson]

DAMMMMMMMMNNNNNNNNNNNN Dave ,the hits just keep rollin outta your shop!!! I've run out of superlatives ...you done slapped me speechless. Dave my man, you are indeed the Yoda of psg building AND finishing...superb my friend, Stormy

[maxi19]

That looks terrific Dave, have a Merry Christmas my friend.

Best Regards

Ron Mc

[sheffield steel]

a few more.

[Farmer]

Hey Dave,
On this one I just don't quite know what to say, but if you sell this one I am thinkn' maybe you auta se one of them fancy doctors.... you know the ones that work on the head.... Just kidding my man, she's a BUTE...
By the way Merry Christmas and Happy New Year To All

Mike

[sheffield steel]

Hi Mike,
This one's not for sale, it's all mine, mine, mine!!! So hopefully I'll not have to see a shrink!!!!
Dave.