McGregor Steel 2nd build in progress
Posted: Sun Nov 18, 2012 3:53 pm
African Mahogany deck, w/Lacewood necks and side rails.
That's a test version in the photos of the laser etched, Lexan fingerboards provided by Mark Bracewell of Willow Glen Guitars. Nickel plated brass bridges by Ryan Rukavina, two pair of cut down MSA keyheads, and used aluminum endplates from a pedal steel. I'm installing Jerry Wallace TT8's, and have left enough room between the necks for a Tele style control plate that will have Volume, Tone, and a 3-way switch. The far neck is 3/4" higher than the near one. This is something I'm trying. I think I find more difference in neck heights than you usually have on console feels better to my style of moving the bar around.
Lot of work left to do.
I still have to drill all the screw holes, glue up the decks and rails, a lot of final sanding, finish shaping the brass nuts, apply my sanding sealer and nitro, polish up all the hardware, install everything, and wire it.
I'm learning a lot during the process. Deciding to install controls has made this project a lot more complicated. Everything has to fit into a limited space.