Need advice about using a water based finish.
Posted: Wed Apr 05, 2017 7:29 pm
Hi All, I am finally getting around to finishing up a lap steel that I started about eight years ago. It is made from White Ash that was harvested from a tree that we cut and milled about 13 years ago. I have been researching different finishes and prefer water based. I have built three previously, and used MinWax Polycrylic with so, so results. All previous builds were just clear coated with multiple layers and no staining or dyeing of any kind. This time I have used leather dye mixed in denatured alcohol, applied until I think I have the shade I'm looking for. I don't have any spraying equipment and will be brushing. I have seen in some previous searches about applying a sealer on top of dyed surface before applying the finish coats. I believe a vinyl sealer was recommended under lacquer. I plan on trying out a product that I just discovered, KTM-9 a water-based finish. On the LMI website they recommend using an epoxy filler under it for a pore filler. My questions are: Is White Ash considered a porous wood? What Has anyone tried using the KTM-9 and if so, what were the results? Is a pore filler needed, and what results can I expect using vs. not using a pore filler? I think I have also read that shellac can be used as a sealer before applying the finish coats. Any advice or suggestions will be greatly appreciated. Thank you.
LaVern Skarzenski
LaVern Skarzenski