DIY Reamer
Posted: Sat Apr 16, 2011 2:00 pm
I lost the web page where I found this (Google DIY Reamer). They had 3 diferent types. I used a short piece of my 1/2 inch shaft cut out as per diagram to ream out my finger bushing (brass).
Cut/grind to 1/2 way point on rod and sharpen cutting edgr with a stone. 45 degree chamfer on end makes it semi- self centering.
Low budget but it works!
Cut/grind to 1/2 way point on rod and sharpen cutting edgr with a stone. 45 degree chamfer on end makes it semi- self centering.
Low budget but it works!